American Woodworker

Free Product Guide >>

Syndication

 


 

 

 

Woodwork 

Winter 2013-2014

Preview this issue

 

Tablesaw Jig Clamp

RATE THIS:

I added this hold-down to my tablesaw's sliding cutoff jig and find it a great convenience, because the height of the clamp is easily changed. This clamp uses a standard bar-type caulking gun, cut in half, as shown. The mounting block slides to apply clamping pressure where needed, and I covered the plunger with rubber so it wouldn't mar the workpiece. One squeeze of the handle and the work is locked in position — and all for less than $3!

 


Comments

punjab wrote re: Tablesaw Jig Clamp
on 04-26-2009 9:37 AM

good thinking and not expensiv to make. will have to make one these.

carporter wrote re: Tablesaw Jig Clamp
on 06-05-2009 10:47 AM

A very good ideal that I can use and use for small

projects. Very Smart.