American Woodworker

Important Information >>

Syndication

Q & A: Are Broken Screws Removable?

RATE THIS:

Q & A: Are Broken Screws Removable?


Q:

Argh! I broke off a brass screw while installing a small hinge. Can I get it out?

 

A:

Join the club! Every woodworker has faced this problem.The best answer is to drill around the screw with a hollow bit, an unusual device with reverse teeth. Furniture repair guys used to painstakingly make these screw extracting bits themselves, but now we can buy three sizes for about $14 each from a mail-order catalog.

Here’s what you do: Buy a hollow bit with an inside diameter that’s larger than the screw. Use a drill press to make a perpendicular hole in a piece of scrap that’s the outside diameter of the hollow bit.This guide block keeps the bit from wandering.Clamp the guide block over the broken screw.Then chuck the hollow bit in a portable drill set to “reverse.”Drill around the screw.When you get near the bottom of the screw, it will unthread itself from the wood. (The hollow bit’s teeth are backward so they cut when the drill is in reverse.) Sounds too good to be true,but it really works! Plug the hole with a dowel.

Next time you use brass screws,drill a pilot hole first, then screw in a steel screw to thread the wood. Replace the steel screw with a brass one and lubricate it with a toilet wax ring or moist soap shavings.


Source

Note: Product availability and prices are subject to change.

Screw extractors:

Woodcraft, woodcraft.com, 800-225-1153, #124210, 1/4-in. outside dia, (removes up to #8 screw);  #124211, 5/16-in. outside dia. (removes up to #10 screw); #124212, 3/8-in. outside dia. (removes up to #12 screw).




This story originally appeared in American Woodworker February 2001, issue #85.

February 2001, issue #85

Purchase this back issue.