American Woodworker

Important Information >>

Syndication

Q & A: Silencing a Squeaky Tablesaw

RATE THIS:

Q & A: Silencing a Squeaky Tablesaw


Q:

My tablesaw screeches like nails on a chalkboard whenever I adjust the blade.WD-40 made the noise go away for a while, but now it’s back. What do I do?


A:

That sound can drive you crazy! It’s a clear sign that the gears under your saw are due for lubrication.The original lubricant has either hardened or worn off, so now you’re hearing the bare steel of the worm gears scrape the bare cast iron of the tilting trunnion and raising gear. You’re unlikely to wear out the gears this way, so it’s not a cause for alarm, but the noise will continue to get worse.

The best fix is to lubricate the gears with lithium grease, the same stuff they use at the factory.You can buy a lifetime’s supply ($6 for a 1-lb. tub) at an auto supply store.An alternative is powdered graphite, available at a hardware store or a locksmith’s shop for about $2 a tube.One advantage: it won’t attract dust and chips the way grease does.

Clean the gears with a small brass brush or an old toothbrush and WD-40, which helps soften the grease. Apply a thin layer of new grease to the teeth of the raising gear and the trunnion.Turn the handles a few cranks to transfer the grease to the worm gears and enjoy the sound of silence.




This story originally appeared in American Woodworker December, 2001.

December, 2001

Purchase this back issue.