American Woodworker

Important Information >>

Syndication

Woodworking Shop

  • AW Extra 7/26/12 - Master Your Brad Nailer

    by AW-Editor     Monday, July 7, 2008
    Master Your Brad Nailer 5 Tips and products to make your brad nailer safe and easy to use . Avoid the blowout curse A brad that unexpectedly shoots out the side of your project is guaranteed to make you curse, especially if your finger happens to be in...
  • AW Extra 5/17/12 - Is Your Miter Saw Square?

    by AW-Editor     Sunday, June 29, 2008
    Question & Answer Is your miter saw square? Q. I want to adjust my miter saw so it’s dead-on accurate, but I don’t have a fancy square. How do I do it? A. Use an old woodworker’s trick: set up your saw as close as you can with whatever...
  • Zero Clearance Dust Port

    by American Woodworker Editors     Tuesday, June 30, 2009
    Zero clearance inserts are wonderful for eliminating tearout, but unfortunately, they also impede dust collection. To give my collection system an opening to pull sawdust through, I cut a 1/2-in.-dia. hole at the front end of the blade slot. In this location...
  • AW Extra 8/2/12 - Jointing with a Planer

    by AW-Editor     Monday, July 7, 2008
    Jointing with a Planer I came across some wonderful oak boards for a small table I wanted to build. The problem was the boards were too wide for my jointer and I didn't want to rip them any narrower. I solved my dilemma with this planer sled that...
  • Double Scrollsaw Blade Life

    by American Woodworker Editors     Thursday, October 15, 2009
    When my scrollsaw blade gets dull, it’s really only dull on the bottom half, because the wood I cut is usually less than 1/2 in. thick. To get more life out of my blade, I made an auxiliary table that raises the workpiece, so I can cut with the...