American Woodworker

Important Information >>


Drill Press Bottom Board





I used to have trouble clamping to my drill press table because the underside was uneven. I fixed this by fitting a board to the bottom of the table. It was a little challenging to get the fit right because of all the webbing and ridges, but I finally got it. I drilled and countersunk a couple of holes in the metal table and attached the board with wood screws.





Filed under: ,
Attachment: drillpress.jpg


Bob Brennan wrote re: Drill Press Bottom Board
on 07-12-2011 7:50 AM

Sorry but I don't get it, why not just make a drillpress jig for on top of the drillpress table?